#59
Непрочитанное сообщение
shadows » Вт мар 10, 2009 11:29 pm
In fect you can made the finishing look even better.
below is some of my idea and hope to shares overhere.
1, you made fibre glass hollow mould, and on the surface, you drill tiny tiny hole around it.
2, you use a dust vacuum machine connect to the hollow mould.
3, you tensile the P.U Leather
4, you use a hair dryer and heat up the P.U Leather till it reach a temperature that the P.U Leather become very soft
5, place the heat up P.U Leather over the mould, than you On the vacuum machine.
through the hole, the vacuum were suck the P.U and form up a very nice shape according to the mould you have.
6, wait for maybe 5 minutes, than you remove the P.U Leather from the mould
7. apply adhesive over a 3mm thickness foam and the armrest.
8, cover the 3mm foam over the arm rest and pull tight
9, apply adhesive on top the foam and beind the P.U Leather and wait for 5 minutes
10, wrap the P.U Leather over the foam gently
11, trimm all edge unfold over the armrest.
Job Done
Be Sure You Don't Missed It !!!